Canarm CESD100-3 Mode D'emploi page 3

CESD100-3
ULTRA QUIET SLIMLINE DESIGN CEILING EXHAUST FAN
ASSEMBLY INSTRUCTIONS
1. Before installation, you need to know:
Screw A
Screw B
Hanger bar
When installing contractor packs, make sure to install any optional modules
such as speed controls or humidity sensors with the fan housing to ensure
wiring is completed properly. Module and grille plugs come packaged with the
optional accessory and must be installed with the fan housing.
2. Mount with mounting holes.
Hold housing in place so that the housing contacts the bottom of the joist and
screw housing to joist through hole A and hole B.
3. Mount with hanger bar.
Slide one hanger bar into the channel on the housing and adjust as needed to
fit between framing. Hold housing in place so that the housing contacts the
bottom of the joist and screw housing to joist through hole A and hole B. Screw
the hanger bar onto the other side of joist through its hole.
Screw hanger bar to housing with screw A.
4. Mount to I-joist.
Slide hanger bar into the channel on the housing and adjust as needed to fit
I-joist. Hold housing in place so that the housing contacts the bottom of joist.
Screw housing to joist through hole A and hole B. Screw the hanger bar onto
the joist through its hole.
Screw hanger bar to housing with screw A.
5. Wall installation.
5a. When the product is installed on the wall, the adaptor shall be faced
upward.
M-CESD100-3 11/24
ST4.2*13mm
ST4.2*25mm
13 3/8" (340mm)
Channel
Hole B
Hole A
Screw B
Screw A
Screw B
Screw A
Screw B
Hole B
Hole A
Screw B
Screw B
Page 3 of 6