Bimar VT7-30B Notice D'instructions page 11

• Do not place the fan on a shelf and/or near sinks or other container of liquids (minimum
distance of 2 meters) to avoid the risk of it falling in.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct
the air intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not
twisted or wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane
(the appliance could upset).
• Do not place the appliance near an open flame, cooking or other heating appliance.
• In the event of a breakdown or poor operation, turn the fan heater off and ask for
professionally qualified help.
ASSEMBLY
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if
the power cord is damaged, it must be replaced by the manufacturer or a competent qualified
electrician or a person with similar qualifications, in order to avoid any risk.
Attention: the fan can be used only when completely and correctly assembled, that is
complete with its base and protection grid.
Attention: always unplug the appliance before you assemble.
If in doubt, have the appliance checked or assembled by a qualified professional person. For
assembly, refer to figure.
1. Insert the lower part of the body in the base (8) (see the figure to
the right), make sure that the 3 hooks come out of their relative
slots.
Attention: without the base the fan can not be used.
1) Front grille
2) Ring perimeter plastic
3) Grille attachment ring nut
4) Rear grille
5) Motor shaft
6) Oscillation button
7) Body
8) Base
9) Selector
10) Fan
11) Screws and nuts for fasten the
grilles
12) Fan attachment ring nut
11/28