Bimar VT7-30B Notice D'instructions page 10

Masquer les pouces Voir aussi pour VT7-30B:
Table des Matières
Les langues disponibles

Les langues disponibles

• Do not pull on the cord to disconnect the plug from the socket.
• Do not allow children, or irresponsible persons, to use the device
without supervision.
• If the electric cord is damaged, it has to be replaced by the supplier or
an authorized service center or a professionally qualified, to avoid any
risks.
• Do not use the appliance with a timer or a programmer or with a
system that can switch on the appliance automatically, to avoid
risk of fire, since a fire risk exists if the applaince is covered or
positioned incorrectly.
• Ensure that the fan is switched off from the supply mains before
removing the guard.
INSTALLATION
• After removing the packing materials, check the integrity of the heater; if you are unsure,
do not use it and ask for qualified professional help. The packing materials (plastic bags,
polystyrene foam, nails, etc.) must be kept out the reach of children because they are
potential sources of danger.
All packaging elements must be disposed of according to their raw material (see the symbol
stamped on each one) and according to the provisions of their municipality.
elements of the packaging with low weight (es: packing tape) are unmarked as are its small
size packing materials, the protective film of surfaces: therefore you have to follow the
procedures for the disposal in force in your municipality.
Attention: any stickers or advertising material applied to the grid removed before using the
appliance. The manufacturer declines all responsibility in case this is not safe working
practices will be respected.
• Before connecting the appliance, check that the voltage values shown on the data plate
correspond to those of the electricity supply network. In the event of incompatibility
between the electric outlet and the plug of the appliance, have the outlet replaced with
another more suitable type by professionally qualified personnel, who will make sure that
the section of the wires of the outlet is appropriate for the absorbed power of the
appliance. In general, the use of adapters or extension cords is not recommended; if their
use is indispensable, they must conform to existing safety standards and their current
capacity (amperes) must not be less that the maximum of the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
10/28
The secondary
Table des Matières
loading

Ce manuel est également adapté pour:

Vt7-40bVt333Vt433

Table des Matières