Initial Start Up - Scotsman Un0815Ax-1A Manuel D'utilisation

UF0915X, UF1415X, UF2020X, UN0815X, UN1215X, and UN1520X User Manual

Initial Start Up

1. Remove the front panel by removing the two screws holding it to the cabinet and pulling the panel down
and off the machine.
2. Turn on the water supply, correct any leaks.
3. Locate the On push button.
Power Status Water De-scale
Sani�ze
4. Confirm that the Power indicator light is on and that the Water indicator light is off.
If the Water indicator light is blinking red, the unit will not start as there is no water sensed and ice cannot be
made. Correct any condition keeping water from filling the reservoir.
5. Push and release the On button.
6. The Status indicator light will be on. Warm air will begin to blow out the left front of the machine and the
auger drive motor will switch on. Within a minute or so the ice will fall down and slide into the ice storage
bin. It is normal for a small amount of water to also drip from the ice making area.
7. Check for any unusual noises, such as fan motor vibration and correct as needed.
8. Return the front panel to its normal position.
On Off
March 2024
Page 12