Pairing The Wireless Remote Control; Pairing The Wireless Remote Control Via The Programming Unit Of The Instantaneous Water Heater When The Appliance Cover Is Closed - Stiebel Eltron FFB 4 EU Utilisation Et Installation

INSTALLATIoN

Pairing the wireless remote control

4
1 Wireless module PCB
2 Locking tabs
3 Wireless module plug position
4 Appliance PCB plug position
f Mount the wireless module PCB in the retainer provided. f
Insert the wireless module PCB into the groove and pivot
downwards. The locking tab must audibly click into place.
f Attach the connecting cable (plugs as shown). f
f Please see chapter "Pairing the wireless remote control" for f
further information on how to proceed. Depending on the
type of pairing with the instantaneous water heater, the ap-
pliance cover may need to be fitted in the next step.
22 | FFB 4 EU | FFB 4 Set EU | FFB 4 AP | FFB 4 Set AP
2 3
1
9. Pairing the wireless remote control
In order to use the wireless remote control, it needs to be paired
with the appliance.
To do this, it is necessary to initiate a pairing process at the ap-
pliance programming unit or wireless module and at the wireless
remote control within 30 seconds.
Note
The appliance power supply must not be switched off
during this time.
9.1 Pairing the wireless remote control via the
programming unit of the instantaneous water
heater when the appliance cover is closed
f Initiate the pairing process at the instantaneous water heater f
using the programming unit. The procedure is described in
the operating and installation instructions of the instantane-
ous water heater.
f Press buttons "1" and "2" simultaneously on the wireless f
remote control for 3 seconds. A flashing "L" indicates that
pairing is in progress.
An "L" displayed for approx. 5 seconds indicates that the pairing
process has completed successfully.
www.stiebel-eltron.com