Operation - Stiebel Eltron FFB 4 EU Utilisation Et Installation

oPERATIoN

Appliance description
3.1 Operation
1
1 Display
2 Progress bar displayed during data transmission
3 Temperature setting OFF, 20 °C - 60 °C (if the instantaneous
water heater is used to supply a shower) in 0.5 °C increments
using the "+" and "-" keys
4 Memory keys "1" and "2"
Shortly after the last setting has been made, the wireless remote
control goes into energy saving mode and the display is switched
off.
The most recently transmitted temperature is still retained in en-
ergy saving mode.
18 | FFB 4 EU | FFB 4 Set EU | FFB 4 AP | FFB 4 Set AP
1
2
3
+
4
2
-
Function of memory keys "1" and "2"
When either of the memory keys are pressed, the temperature
saved for them is briefly displayed. If no other key is pressed within
the next second, the temperature displayed is directly transmitted.
Function keys "+" and "-"
When the "+" or "-" keys are pressed, the most recently transmitted
temperature is briefly displayed. If no other key is pressed within
the next second, the temperature displayed is directly transmitted.
You can change this temperature in 0.5 °C steps by pressing any
other key.
The temperature can be adjusted between OFF, 20 °C and 60 °C,
although if a temperature limit is set in the appliance, this remains
effective.
Holding down "+" or "-" changes the temperature display in 0.5 °C
steps until the key is released again.
When the key is released, the required temperature is transmitted.
The required temperature is transmitted approx. 0.5 seconds after
the last key is pressed. The progress bar on the display indicates
that data is being transmitted.
f To shut down the heating system, set a temperature of 20 °C. f
Then press "-" again.
www.stiebel-eltron.com