Using The Breast Pump - Philips Avent Scd553 Mode D'emploi

14
English

Using the breast pump

Charging the breast pump
3 sec.
3 Gently remove the parts from the water. Leave the
parts to air-dry on a clean tea towel or drying rack.
4 Store the dry items safely in a clean, protected area
until needed. Ensure that the clean parts have air-
dried completely before storing them to help prevent
germs and mold from growing.
The collection cup parts are microwave sterilizer safe and
steam sterilizer safe. Follow the instructions of the
sterilizer manufacturer.
Fully charge the battery before you use the breast pump
for the first time and when the battery is low. Fully
charging the battery takes up to 1.5 hours.
Use a power source (an adapter or a power bank) with a
USB port, of 5 V direct current/1.8 A or 9 W for your
breast pump. Using a power source with lower
specifications might result in slow charging or being
unable to pump while connected to a wall socket.
1 Switch off the device.
2 Insert the small plug of the USB cable into the motor
unit and insert the other end of the USB cable into a
USB power source, e.g. adapter or laptop.
3 The battery lights light up one by one and then all go
out: the battery is charging.
4 All 3 lights are steady on: the battery is fully charged.
5 Remove the USB cable from the USB power source
and pull the small plug out of the motor unit.