CONSTRUCTA CC4P91262 Manuel D'utilisation Et Notice D'installation page 31

Setting Selection Meaning
1
Button tone
Demo mode
9.2 Changing basic settings
Requirement: The appliance is switched off.
Press and hold and
1.
The display shows the first basic setting.
Press .
2.
The current value flashes on the display.
Use the settings area to set the required value.
3.
To accept the basic setting, press
4.
To exit the basic setting, press
5.
Use the settings area to switch to the basic setting .
6.
To edit the basic setting, press
7.
The selected setting lights up on the display.
Use the settings area to set the required value.
8.
To accept the basic setting, press
9.
To exit the basic setting, press
10.
To exit the basic settings menu, press
11.
Tip: The setting can be changed at any time.
9.3 Changing the signal duration
When your appliance is switched off, you hear an aud-
ible signal. You can change the duration of the signal.
10 Cleaning and servicing
Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
10.1 Cleaning products
Only use suitable cleaning agents.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Do not use steam- or high-pressure cleaners to clean
the appliance.
ATTENTION
Unsuitable cleaning agents damage the surfaces of the
appliance.
Do not use harsh or abrasive cleaning products.
Do not use cleaning products with a high alcohol con-
tent.
Do not use hard scouring pads or cleaning sponges.
Do not use any special cleaners for cleaning the ap-
pliance while it is hot.
Only use glass cleaners, glass scrapers or stainless
steel care products if recommended in the cleaning
instructions for the relevant part.
1
Factory setting (may vary according to model)
Switch the button tone on and off.
Note: The button tone remains active for
Activate or deactivate demo mode.
Note: The appliance is switched off. You can use the buttons and the display; the but-
tons do not work. Demo mode is mainly useful for dealers.
for a few seconds.
.
.
.
.
.
again.
and .
Press and hold for approx. six seconds.
The signal duration switches between short and long.
The appliance applies the signal duration and dis-
plays the time.
9.4 Setting the time
Note: After connecting the appliance to the power or fol-
lowing a power cut, a signal sounds and several zeros
are shown on the display. It may take a few seconds un-
til a signal sounds and you can set the time.
Requirements
An audible signal sounds.
12:00 is shown on the display.
The indicator light lights up via
Set the time via the settings area.
1.
Press .
2.
9.5 Hiding the clock
To reduce the standby consumption of your appliance,
you can hide the clock.
Press .
1.
Press .
2.
To view the clock, press
Salt contained in new sponge cloths may damage sur-
faces.
Wash new sponge cloths thoroughly before use.
You can find out which cleaning products are suitable
for each surface or part of the appliance in the indi-
vidual cleaning instructions.
10.2 Cleaning the appliance
Clean the appliance as specified. This will ensure that
the different parts and surfaces of the appliance are not
damaged by incorrect cleaning or unsuitable cleaning
products.
WARNING ‒ Risk of fire!
Loose food remnants, fat and meat juices may catch
fire.
Before using the appliance, remove the worst of the
food residues and remnants from the cooking com-
partment, heating elements and accessories.
Cleaning and servicing en
.
again.
31