The installation of the appliance and the condenser unit may only be carried out by our
local service organisation team or a qualified installer. The type of condenser unit to be
used is to be determined in consultation with your local service organisation or a
qualified installer.
• Install the cabinet following the instructions.
• Connect the waste pipe to the drains.
• Ensure that the drain pipe slopes down and is
fitted lower than the evaporator drip tray in
the cabinet.
• Fit a siphon to prevent bad odours coming
into the cabinet.
• Pay attention that the siphon does not
obstruct the flow too much.
• Fit separate waste pipes for a drip tray and
rinsing bowl if necessary.
• Always use T-connectors 45º.
• Always connect the overflow to the drains
(in extreme circumstances it may be possible
that the evaporation capacity is not sufficient).
28
4.3
4.4
Fitting the wastepipe
User Manual
Split units