Gamko FK Mode D'emploi page 26

Required tools
1. Place the bottom on the desired position. In case of great unevenness use the
feet to level the product.
Attention: the provided plugs must be fitted into the cavities within
the feet.
2. Mount the back panel on the bottom panel by securing the hook couplings
with a socket-head screw wrench (turn right). All hook couplings are
accessible from the in and outside.
3. Mount the right side panel by means of a socket-head screw wrench.
Attention: the plastic strip has to be on the front side.
4. Mount the left side panel by means of a socket-head screw wrench.
Attention: The front side of the side panels must align with the front
side of the bottom panel.
Note: The left and right panel are the same.
5. Carefully place the top panel on the back and side panels and mount by
means of a socket-head screw wrench.
6. Screw the hinge pins(2) in the bottom side of the top panel.
7. Place the left and right doors into the upper hinge pins.
8. Place the left and right doors into the upper hinge pins.
9. Adjust lower hinges. Mount the hinge pins from below and secure by means of
a screw wrench.
10. Mount the middle post with screws.
11. Place the cooling unit in the cavities of the top panel. The condenser must be
visible from the front side for easy access and cleaning.
Attention: All the coupling holes must be fitted with an rivet from the
in and outside.
26
: Socket-head screw wrench 6mm
Screw wrench M10
Screw driver
User Manual