Wear Limits Of The Blades; Service Interval Of The Combustion Engine - Viking GB 460 Manuel D'utilisation

● After sharpening, remove any
sharpening burr at the cutting edge
using fine sandpaper.

12.9 Wear limits of the blades

The blades must be reversed or
replaced before reaching the
specified wear limits (A, B, C, D).
VIKING recommends VIKING
specialist dealers.
The specified values should be
measured at several points (two or
three recommended) along the
cutting edge on all the blades.
Use the smallest value for a blade.
We recommend that you always
reverse or replace all the blades at
the same time.
1 Blade overview
2 wing blades (1)
6 blades (2)
1 blade (3)
1 counter-blade (4)
Soft material blade disc:
The soft material blade disc is fitted with
four blades.
Hard material blade disc:
The hard material blade disc is fitted with
two blades and one chipping blade.
● Removing the blade discs. (
2 wear limit of wing blades (1):
The measurement procedure and
the value specified are the same for
both wing blades.
0478 216 9905 D - EN
Asymmetrical wear may occur at
the two wing blades due to uneven
use of the cutting edges.
Minimum blade width (A) of the two wing
blades (1):
A = 39 mm
29
3 Wear limit of blades (2):
The blades (2) are reversible
blades. After reaching the specified
wear limit (B), the blade can be re-
sharpened and reversed until the
wear limit is reached, before
needing to be replaced.
● Measure the distance (B) shown in the
illustration from the large diameter of
the bore to the cutting edge (X).
● Repeat this procedure at the second
bore on the blade.
Minimum distance (B) on the blades (2):
B = 6 mm
The particular blade (2) must be
reversed or replaced if one of the
two distances measured is less
than the minimum distance (B).
4 Wear limit of blade (3):
The blade (3) is a reversible blade.
On reaching the specified wear
limit (C), the blade (3) can be re-
sharpened and reversed until the
wear limit is reached, before
needing to be replaced.
● Measure the distance (C) at a right
angle to the cutting edge.
12.3)
Minimum distance (C) on the blade (3):
C = 7 mm
The blade (3) must be reversed or
replaced if the distance measured
is less than the minimum
distance (C).
5 Wear limit of counter-blade (4):
Asymmetrical wear may occur at
the counter-blade (4) due to
uneven use of the cutting edge.
● The counter-blade (4) must be replaced
before the edge (D) at the tip (5) of the
blade is ground down and no longer
visible.
12.10 Service interval of the
combustion engine
Maintenance interval:
Before each use:
Perform oil check ( engine instruction
manual). Observe the operating and
maintenance instructions contained in the
accompanying engine instruction manual.
12.11 Service intervals
Service by the specialist dealer
We recommend that you have your garden
shredder serviced once a year by a
specialist dealer.
VIKING recommends VIKING specialist
dealers.
Professional use (commercial use of the
garden shredder):
every six months
Private use:
once a year
65