Mode - Heating Mode; Pairing; Settings - Fenix V24 WIFI Guide D'utilisation


Step 2: After some seconds, the first
networks are found
Use the arrows UP and DOWN to find your network in
the list.
If the network you are searching is not in the list:
press the "Refresh" button until you see your
network. If after 2 minutes, your network is not
found, then the best way is to connect your V24
WIFI via Manual procedure.
Use the arrows UP and DOWN to find your network in
the list, the network selected is the one in red. When
the correct network is in red, then validate.

Step 3: Key type
Select the key and validate (WPA 2 is the most
common key)

Step 4: enter the Key
Enter the key and validate

Step 5: connecting to network
Just wait until the V24 WIFI comes back to WIFI
menu.The status must be now "Connected".
If in the end, it fails (Status "Not connected"), wait
some minutes more, if it is still "Not connected" then
verify the SSID, the Key and retry.
MODE – Heating mode
3.1.7
When programming the individual zones, each zone
can be allocated a different operating mode. In this
menu, one identical operating mode is applied to all
zones simultaneously.
Press the required operating mode, which will highlight
it, and confirm your selection by pressing the (OK)
button.
Example: "AUTO" mode will be set for all the zones
WARNING – this setting will only be applied
to zones which are regulated on the basis of
temperature. The setting doesn´t apply to zones in
which the receivers are in the ON/OFF mode.
3.1.8

Pairing

Pairing procedure has been already explained in
Installation chapter 2.1.
1) "New Heating Zone": to pair a heating zone
2) "New ON/OFF Zone": to pair a zone ON/OFF
3) "Delete": to delete a zone (ON/OFF or Heating zone)
from the installation
Choose the zone to delete with (<)(>) and click on
"Delete" button: the text on the button changes to "Yes"
to confirm the choice. By pressing again to the button,
it deletes the zone.
3.1.9

Settings

Note: the red point at the top right corner of the button
indiquates that user needs to press 3 seconds the
button to enter the menu
1) Update Product:
Use this menu to update the version of the V24 WIFI.
Once in this menu, you have the possibility to confirm
(Yes) or to cancel (No), if you want to update the
product, insert a micro SD with the new software
named "update.bin".
7