FR
2.4. ASTUCES ET CONSEILS D'INSTALLATION
2.4.1. Questions sur l'OXIMO 40 AUTO io ?
Constats
Le produit motorisé
ne fonctionne pas.
La motorisation
OXIMO 40 AUTO io
tourne dans un seul
sens.
/D ¿[DWLRQ GX WDEOLHU
du volet roulant sur le
tube d'enroulement
doit être modifée.
La position favorite
est décalée.
0RGL¿FDWLRQ GX VHQV GH URWDWLRQ
/H VHQV GH URWDWLRQ SHXW rWUH PRGL¿p j WRXW PRPHQW j O¶DLGH G¶XQ SRLQW GH FRPPDQGH ORFDO
®
io-homecontrol
Somfy enregistré :
Positionner le produit motorisé à mi-hauteur..
1)
2)
$SSX\HU VXU HW 9 MXVTX¶DX YDHWYLHQW GX SURGXLW PRWRULVp
Appuyer sur my jusqu'au va-et-vient du produit motorisé :
3)
/H VHQV GH URWDWLRQ HVW PRGL¿p
$SSX\HU VXU
SRXU FRQWU{OHU OH QRXYHDX VHQV GH URWDWLRQ
4)
8
Causes possibles
Le câblage est incorrect.
La motorisation est en protection
thermique.
La pile du point de commande
®
io-homecontrol
est faible.
Le point de commande n'est pas
compatible.
Le point de commande
io-homecontrol
®
utilisé n'est pas
enregistré dans la motorisation.
L'OXIMO 40 AUTO io est trop proche
GH VHV ¿QV GH FRXUVHV RX GX GHUQLHU
obstacle rencontré.
/HV YHUURXV VRQW PDO ¿[pV
La course du produit motorisé a été
PRGL¿pH
Images non contractuelles
Solutions
&RQWU{OHU OH FkEODJH HW OH PRGL¿HU VL EHVRLQ
Attendre que la motorisation refroidisse.
&RQWU{OHU VL OD SLOH HVW IDLEOH HW OD UHPSODFHU
si besoin.
Contacter un interlocuteur Somfy.
Utiliser un point de commande enregistré ou
enregistrer ce point de commande.
V
Appuyer sur
ou
l'OXIMO 40 AUTO io.
0RGL¿HU O¶LQVWDOODWLRQ SRVLWLRQ GHV
verrous), remettre l'OXIMO 40 AUTO io
HQ FRQ¿JXUDWLRQ G¶RULJLQH HW UHSUHQGUH
l'installation complète à partir du chapitre
Mise en service.
Attendre le recalage automatique au bout de
quelques cycles ou reprendre l'installation
complète de l'OXIMO 40 AUTO io à partir du
chapitre Installation.
1)
3)
Copyright © 2014 Somfy SAS. All rights reserved.
pour débloquer
2)
4)