Publicité
These instructions apply to all versions of the OXIMO 40 AUTO io (torque/speed).
1. Prerequisite information
1.1 Field of application
1.2 Liability
1.3 Content
2. Installation
2.1. Assembly
2.2. Wiring
2.3. Commissioning
2.4. Tips and recommendations
for installation
7KH 2;,02 $872 LR GULYH GRHV QRW UHTXLUH DGMXVWPHQW D VLPSOH FRQQHFWLRQ LV DOO WKDW LV UHTXLUHG
The OXIMO 40 AUTO io drive automatically programs its end limits.
The OXIMO 40 AUTO io drive can be mounted either on the right or on the left.
,W LV ¿WWHG ZLWK
obstacle protection to protect the roller shutter when it is being lowered.
-
anti-freeze protection to protect the roller shutter when it is being raised.
-
1. PREREQUISITE INFORMATION
1.1 FIELD OF APPLICATION
The Oximo 40 Auto drive is designed to motorise all types of roller blinds equipped with stops and
ULJLG OLQNV ZKLFK IXO¿O DW OHDVW RQH RI WKH IROORZLQJ FRQGLWLRQV
- The motorised product is controlled by a switch without a locking device (see the attached Safety
instructions document).
- When deployed, all parts of the motorised product are more than 2.50 m above ground or any other
permanent access level.
7KH DSURQ RI WKH UROOHU EOLQG FDQ EH UDLVHG E\ FP LI D IRUFH RI 1 LV DSSOLHG XSZDUGV RQ WKH ¿QDO
slat placed 16 cm from its fully-deployed position.
If the roller shutter has slats which can open, the openings must not allow a pin of diameter 5 mm
to pass through.
Copyright © 2014 Somfy SAS. All rights reserved.
ORIGINAL INSTRUCTIONS
CONTENTS
21
21
22
22
22
22
24
24
26
3. Use and maintenance
3.1. Up and Down buttons
3.2. STOP function
3.3. Favourite position (my)
3.4. Operating with a Somfy
io-homecontrol sun sensor
3.5. Additional settings
3.6. Tips and recommendations for use 29
4. Technical data
Images not contractually binding
EN
28
28
28
28
28
28
29
21
Publicité
