Publicité
EN
2.4. TIPS AND RECOMMENDATIONS FOR INSTALLATION
2.4.1. Questions on the OXIMO 40 AUTO io?
Observations
The motorised
product does not
operate.
The OXIMO 40
AUTO io drive
rotates in one
direction only.
The roller shutter
mounting on the
roller tube must be
PRGL¿HG
The favourite
position has shifted.
2.4.2 Changing the direction of rotation
The direction of rotation may be changed at any time using a paired Somfy io-homecontrol
SRLQW
Position the motorised product at the mid-height position.
1)
2)
3UHVV
DQG 9 XQWLO WKH PRWRULVHG SURGXFW PRYHV XS DQG
down.
3UHVV P\ XQWLO WKH PRWRULVHG SURGXFW PRYHV XS DQG GRZQ
3)
7KH GLUHFWLRQ RI URWDWLRQ KDV EHHQ PRGL¿HG
3UHVV WR FRQWURO WKH QHZ GLUHFWLRQ RI URWDWLRQ
4)
26
Images not contractually binding
Possible causes
The wiring is incorrect.
The drive is in thermal protection
mode.
®
The io-homecontrol
control point
battery is low.
The control point is not compatible.
The io-homecontrol
®
control point
used has not been programmed into
the drive.
The OXIMO 40 AUTO io is too close
to its end limit positions or to the last
obstacle encountered.
7KH EROWV DUH LQFRUUHFWO\ DI¿[HG
The travel of the motorised product has
been changed.
Solutions
Check the wiring and modify it if necessary.
Wait for the drive to cool down.
Check whether the battery is weak and
replace it if necessary.
Please contact a Somfy adviser.
Use a programmed control point or program
this control point.
V
Press
or
to unlock the OXIMO 40 AUTO
io.
To change the installation (position of
the bolts), restore the default settings
of the OXIMO 40 AUTO io and repeat
the full installation procedure from the
Commissioning section.
Wait for automatic resetting at the end of
several cycles or repeat the full installation
procedure on the OXIMO 40 AUTO io from
the Installation section.
1)
3)
Copyright © 2014 Somfy SAS. All rights reserved.
®
control
2)
4)
Publicité
