Segway Ninebot eKickScooter E2 Plus II Manuel Du Produit page 5

EN
Recommended Maintenance Schedule
6
To ensure safe riding, day to day care and regular maintenance are essential. You, the owner, have control and knowledge
of how often you use your scooter, how hard you use it and where you use it. It is the owner's responsibility to perform
regular checks and bring your scooter to authorized service center for inspection and service. Please refer to the
maintenance schedule below.
Note: This maintenance schedule charges a service fee.
Item Component Maintenance Method
Mainframe parts Use a soft, wet cloth to wipe the mainframe clean.
Check if the tires are cracked, deformed, or
Tire wear
significantly worn.
Tighten the six screws fixed with the handlebar and
the stem. The suggested torque is 5.5±0.3 N·m.
Tighten the screw on the throttle. The suggested
Mainframe
Screws on the
torque is 2±0.1 N·m.
maintenance
stem top
Tighten the screws on the brake levers. The
suggested torque is 5±0.1 N·m.
Tighten the screws on the stem top. The suggested
torque is 2±0.1 N·m.
To accelerate and decelerate, check if the hub motor
Hub motor
is stalled or has abnormal sounds.
Rear wheel Check if the rear wheel is stalled or gets shaky, or the
axis shaft is unbalanced.
maintenance
Function
1) Spin the rear wheel, it spins normally. The rear wheel
Inspection
shall not stuck or make abnormal sounds.
Note: Slight noise does not affect riding safety. But if the
Drum Brake
drum brake makes loud noises when you apply brakes,
please contact customer service for support.
2) Squeeze the brake lever, the rear wheel stops moving.
07
Every 6 After 2 years
months or or the total
Every 3
every 310 mileage > 3107
months
miles (500 miles (5000
km) km)
√ √ √
√ √
√ √ √
√ √
√ √
√ √
√ √
Item Component Maintenance Method
Ambient light Check the ambient light and see if it lights normally.
Headlight Check the headlight and see if it lights brightly.
Dashboard Power on the scooter, the dashboard works properly.
Press and hold the throttle, then release it, checking for
Throttle
acceleration and deceleration.
After connecting with the Segway Mobility app:
Function
1) Update the firmware to the latest version.
Inspection
Fault
2) Check if the notification of the corresponding error code and
detection
possible causes will prompt when the scooter detects an error.
Charge the scooter:
1) Check if the current battery power displays on the dashboard.
Charging
2) Check the LED indicator on the battery charger.
Charging: red, Fully charged: green.
Buttons
Press or toggle the button 3 times without failure.
Test with left turns and right turns (the steering angle is 60°).
Steering
No resistance or lag when turning.
The battery need to be replaced when it is charged and
discharged for 500 times or the total mileage is more than
Battery
6213 miles (10000 km).
assembly
Important
Note: It is recommended to charge once every 60 days for
parts
long-term storage.
Controller
It is required that original Segway-Ninebot parts shall be
used for repairs and replacements.
Hub motor
EN
Every 6 After 2 years
months or or the total
Every 3
every 310 mileage > 3107
months
miles (500 miles (5000
km) km)
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√
08