Techness RUN 100 Manuel D'utilisation page 49

Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the right
and left bolt clockwise reasonably and inspect for proper tension. When an adjustment is made
to the belt tension, you must also make a tracking adjustment to compensate for the change in
belt tension.
DO NOT OVERTIGHTEN - Over tightening will cause belt damage and premature bearing
failure. . . .
4 4 4 4 . . . . 6 6 6 6 Belt Belt Belt Tracking Tracking
Belt Tracking Tracking Adjustment
This treadmill is designed to keep the belt reasonably centred while in use. It is normal for
some belts to drift near one side while the belt is running with no one on it. After a few
minutes of use, the belt should have a tendency to centre itself. If during use, the belt
continues to move toward one side, adjustments are necessary. The procedures are as below:
▲ First set speed at lowest position.
▲ Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using 6mm
Hexagonal Wrench, until the belt is centered itself; If belt shifts to left, tighten the left bolt
and loosen the right bolt by using 6mm Hexagonal Wrench, until the belt is centered. When
adjusting the belt using the 6 mm Hexagonal Wrenches, it is important to adjust the belt in
half turn increments. Over adjusting the belt can cause damage to the mat.
5. 5. 5. 5. TROUBLE TROUBLE TROUBLE SHOOTING TROUBLE SHOOTING SHOOTING SHOOTING
This treadmill is designed in a way that in the event of an electrical fault, the machine will
turn off automatically to prevent any injuries to the user and to prevent damage to the
machine (i.e. motor).
When the treadmill behaves erratically, simply reset the treadmill by turning the power
switch off, waiting for 1 minute then turning the power button back on.
If, after you have reset the treadmill, it is still not running correctly, please run the self-
checking analyse (please refer to Self-Checking
the machine is encountering.
Before Before attempting attempting any any
Before Before attempting attempting any any work
Do Do not not use use extension extension
Do Do not not use use extension extension leads
Adjustment Adjustment
Adjustment
Self-Checking Self-Checking Self-Checking) to distinguish what type of error problem
work on on on on the work work the the treadmill, treadmill,
the treadmill, treadmill, ensure
plug plug plug is is is is removed removed removed from from
plug removed from from the
leads leads leads as as as as it it it it may may may
may lead
ensure ensure that that the the
ensure that that the the power
the the power power point. point.
the power power point. point.
lead lead lead to to to to power power power decrease decrease
power decrease decrease and
49
power power is is is is off power off off and and the the
off and and the the
and and failure. failure.
and failure. failure.