Publicité
STEPS TO RUN ICE MACHINE CLEAN CYCLE
1.Turn off ice machine - press power on/off button
2.Remove Ice from bin & evaporator
a.Wait for ice to melt off evaporator, leave the door open (approximately 30
to 60 Minutes)
b.Remove remaining ice from the bin. (discard or store in a freezer until
cleaning is complete)
3.Remove evaporator cover to expose evaporator and water trough
4.Pour 1 to 2 oz. of Nickle Safe Ice Machine Cleaner in the Water Trough
(more cleaner depending on scale and timing in between cleanings)
a.Press Power on/off button to power unit back on
5.Press CLEAN Button for over 3 seconds to enter cleaning cycle
a.The unit will now run cleaning cycle for 30 minutes
b.If excessive scale has built up, a second cleaning
cycle may be required. Repeat Steps 4-5
6.After the cleaning cycle is complete
a.Check to see if scale is visible on other parts in the interior of the ice
machine. If so move to step 7 or if no visible scale move to step 8.
7.Make a solution of 1-2oz of Nickel Safe ice machine cleaner with 2 quarts
of water, then use a sponge or rag to wipe the interior of the bin, water
reservoir, tubing, evaporator cover, and back of the door. DO NOT WIPE
OR TOUCH THE EVAPORATOR.
a.After wiping down is complete create a solution of 1 Tablespoon Bleach
in 1 Gallon of warm water. This solution will remove the ice machine
cleaner. Repeat the wipe down with this solution. (Be careful of using other
cleaners to avoid possible chemical reactions)
b.Now using just water gently rinse the same parts. Again, DO NOT
TOUCH OR PUT WATER ON THE EVAPORATOR.
8.Reinstall the Evaporator Cover
9.Turn power on – press power on/off button
a.Machine will move into ice making mode.
10.Discard the first 2 harvests of ice, which will take around 60 Minutes.
Your Ice Machine is now clean and ready to make ice again.
- 23 -
Publicité
