Publicité
Always disconnect power at the source before working on the unit.
Failure to unplug the clear ice machine could result in electrical shock or
personal injury.
•Do not touch the power plug when your hands are wet.
•Never unplug the unit by pulling on the cord. Grasp the plug and pull out
firmly.
CONNECTING THE WATER SUPPLY
1.Turn off the main water supply. Turn on the nearest faucet long enough to
clear a line of water.
2.Find a 1/2" to 3/4" vertical cold-water pipe near the installation location.
The distance should be less than 9 feet.
3.Install a shut-off valve to the main water supply. If the water pipe has a
plain piece of copper tubing, attach a 1/4" O.D. compression union to the
tubing and remove the nut.
4.Thread the nuts of the supplied water supply hose to the tap and water
inlet valve. Access to the water inlet valve is through the opening in the rear
panel. Tighten firmly by hand, then one- half turn with a wrench.
5.Turn on the main water supply and tap. Check for leaks in the water
supply connection. Tighten all connections.
WATER SUPPLY TIPS
•Check for leaks after connecting the water line.
•The ice machine requires a continuous water supply with a minimum
pressure of 20 psi (0.138 MPa) and a static pressure not to exceed 80 psi
(0.55 MPa).
•The manufacturer recommends filtering the water. A water filter helps
remove taste, odors and particles. Using softened water may result in
white, mushy cubes that stick together. Avoid using deionized water.
•Using a RO filter may cause the water pressure lower than the minimum
WARNING
Electrical Shock Hazard
- 12 -
Publicité
