Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Fig. E
On/Off Switch (Fig. A)
•
To switch the tool on, depress the on/off switch
the "I" position.
•
To switch the tool off, depress the on/off switch
the "O" position.
Paper Punch (Fig. F, G)
A paper punch
2
is provided with your sander to let you
perforate regular sandpaper to make dust collection possible.
To perforate your sandpaper, install the sandpaper on the
tool as instructed in this manual. With the sander turned
off and unplugged, place the paper punch on the paper so
that the tabs at the edges of the punch are against any two
adjacent sides of the sanding pad. Press the punch against
the pad so that the 8 points penetrate the paper. (Press
the punch into the pad as far as it will go.) Remove the
paper punch and the paper is ready. An alternate method
of perforating the paper is to fasten the punch down to a
suitable work surface and press the sander (with the paper
attached) down on the punch. Two holes are provided in
the punch for this purpose. Use #8 flat head screws.
2
Fig. F
6
Fig. G
Dust Collection (Fig. H, I)
WARNING: Collected sanding dust from sanding
surface coatings (polyurethane, linseed oil, etc.)
can self ignite in sander dust bag or elsewhere
and cause fire. To reduce risk, empty bag frequently
4
at
and strictly follow sander manual and coating
manufacturer's instructions.
4
at
•
The dust bag
10 minutes of sanding.
•
To attach the dust bag to the sander, line up the
grooves on the side dust bag collar with the dust bag
locks on the dust port
•
Slide the dust bag onto the dust port and turn the dust
bag clockwise to lock it in place.
•
To remove, turn the dust bag counterclockwise and
slide off the dust bag.
•
To empty the dust bag, remove it from the dust port
and dump the sanding debris into an appropriate
trash receptacle.
Fig. H
3
should be emptied after every
.
6
3
6
Publicité
Table des Matières
