Télécharger Imprimer la page

Meec tools 026145 Traduction Des Instructions D'origine page 17

Publicité

8
Troubleshooting
Error
The engine does not
start or the has low
The battery is discharged.
power.
There are loose parts or the auger is
Heavy vibrations.
damaged.
The ejector chute is blocked.
The product does
not throw snow.
A foreign object has blocked the auger.
The rotor drive belt is loose or damaged.
9
Technical data
Parameters
Working width
Max. working height
Max. throwing distance
Output
Battery capacity
Battery type
Protection class
Rpm
Dimensions (LxW)
Weight
Noise levels
Sound pressure level, LpA
Measured sound power level, LwA
Guaranteed sound power level,
LwA
Maximum vibrations level1
1 The declared values for vibration and noise, which have
been measured according to a standardized test method,
can be used to compare different tools with each other
and for a preliminary assessment of exposure. The mea-
surement values have been determined in accordance
with EN 62841-1:2015
Cause
Specification
51 cm
27 cm
8 m
40 V
4 Ah
Li-ion
IPX5
2000/min
115 x 55 cm
15 kg
70.1 dB(A), K=3 dB
84 dB(A), K=3 dB
87 db(A), K=3dB
0.9 m/s2, K=1.5m/s2
Charge the battery.
Stop the engine immediately and wait until all
moving parts have stopped. Do a check for any
damage. Tighten all screws. Repair if necessary.
Contact an authorized service center if the
problem persists.
Stop the engine immediately and wait until all
moving parts have stopped. Clear the ejector chute
with a tool or a stick.
Switch off the engine immediately and remove the
foreign object from the auger.
Replace the belt.
Warning! Always wear hearing protection!
Warning! The actual vibration and noise level when
using tools may differ from the specified maximum value,
depending on how the tool is used and the material. It is
therefore necessary to determine which safety precautions
are required to protect the user, based on an estimate of
exposure in actual operating conditions (taking into account
all stages of the work cycle, e.g. the time when the tool is
switched off and when it is idling, in addition to the start-up
time).
Action
17

Publicité

loading