WIKA CTD9100-ZERO Mode D'emploi page 17

10. Specifications
10. Specifications
Specifications
Display
Temperature range
1)
Accuracy
2)
Stability
Resolution
Temperature distribution
3)
Axial homogeneity
Temperature control
Heating time
Cooling time
4)
Stabilisation time
Metal block
Immersion depth
Test bores
Block material
Voltage supply
5)
Power supply
Power consumption
Fuse
Power cord
Communication
Interface
Case
Dimensions (W x D x H)
Weight
1) Is defined as the measuring deviation between the measured value and the reference value.
2) Maximum temperature difference at a stable temperature over 30 minutes.
3) The gradient is understood to be the temperature change in the test well over the first 40 mm from the bottom of the insert.
4) Time before reaching a stable value.
5) AC 115 V power supply must be specified on the order, otherwise an AC 230 V one will be delivered.
The measurement uncertainty is defined as the total measurement uncertainty (k = 2), which contains the following shares:
accuracy, measurement uncertainty of reference, stability and homogeneity.
WIKA operating instructions temperature dry well calibrator, model CTD9100-ZERO
CTD9100-ZERO
-10 ... 0 ... +100 °C (14 ... 32 ... 212 °F)
0.05 K at 0 °C (32 °F), otherwise 0.1 K
< 0.05 K
0.1 °C
< 0.05 K
15 min from -10 °C to +100 °C (from 14 °F to 212 °F)
5 min from 23 °C to 0 °C (from 73 °F to 14 °F)
10 min from 100 °C to 0 °C (from 212 °F to 14 °F)
depending upon usage and area of application
150 mm (5.91 in)
7 bores with Ø 6.5 mm (0.26 in)
Aluminium
AC 100 ... 240 V, 50/60 Hz
225 VA
3.15 A slow blow fuse (at AC 250 V)
for Europe, AC 230 V
RS-485
160 x 230 x 320+50 mm (6.3 x 9.1 x 12.6+2 in)
7 kg (15.5 lbs)
EN
17