Safety Instructions - Kemper KHS CoolFlow Manuel D'utilisation

Safety instructions

Be sure to read and follow the safety instructions in this manual.
Failure to follow the safety instructions can result in injury or
even death and in damage to property.
Safety instructions are identified by symbols. The safety instruc-
tions are introduced by signal words that express the extent of
the hazard.
The following safety instructions are used in this manual:
Danger!
Indicates hazards that might result in severe or
fatal injury.
Warning!
Indicates hazards
that may result in injury, material damage or
contamination of the drinking water.
Note!
Indicates hazards that may result in damage to
the system or malfunctions.
Info
Indicates additional information and tips.
Intended use
The cold water chiller may only be used for chilling drinking
water. It is intended for use in commercial facilities (e.g. Schools,
nurseries, small systems, department stores, holiday homes, etc.).
Any other use is considered contrary to the intended use and is
therefore forbidden. Use only use glycols of Type "L", correspon-
ding to liquid category 3, or water as process medium.
Use the water chiller only in closed rooms in buildings with an air
circulation without aggressive gases and liquids.
Use the system:
• Only when it is in a flawless condition
• In according with the intended use
Misuse
Do not use the cold water chiller to cool liquids other than
drinking water. Do not fill the system with refrigerants, gases,
inflammable or explosive media. Do not use the cold water chiller
on an uneven or unstable surface.
Safety instructions
Obligations of the system owner
The system owner is the person who employs the cold water
chiller commercially. The system owner must ensure the safe
operation and proper condition of the system.
Maintenance and repair
Be sure to observe the specified maintenance intervals. The
system must be serviced 1x a year according to the manu-
facturer's instructions. Further information on maintenance can
be found in the separate maintenance manual supplied.
Malfunctions
Have faults and malfunctions rectified immediately by a plum-
bing specialist. Further information on malfunctions can be found
in the troubleshooting chart (» Chapter 6.2 "Troubleschooting
chart" on page 49).
By attaching the CE symbol to the unit, the manufacturer
declares that the cold water chiller complies with the
relevant regulations:
Low-voltage directive
2014/35/EU
Construction product directive
EU-BauPVO
Sanitary and drinking water installation
DIN EN 1717 / DIN 1988-100
DIN EN 806-5 / DIN EN 806-4
© www.kemper-olpe.de – 03.2020 / K410061000000-00 – 27 /124
EN