Simons Voss Technologies Digital SmartHandle AX Reader on both sides Guide Abrégé page 32

9. Installing the fitting
16
17
18
9. Installing the fitting
ü Door pre-drilled.
ü PH2 screwdriver at hand.
ü TX15 screwdriver at hand.
ü Vernier calliper at hand.
ü Pincers at hand.
1. For S, M and L: measure the door thickness.
19
2. For S, M and L: determine the cutting points on the cut-to-length
screws.
20
3. For S, M and L: shorten the cut-to-length screws.
21
4. For 7 mm spindle: insert the adapter sleeve onto the side of the spindle
with the pin.
22
5. Insert the spindle with the pin side into the fitting.
9 Pin will snap into position in the mount.
23
24
6. For 8.5 mm, 9 mm and 10 mm spindles: slide the adapter sleeve into the
centre of the spindle. Use a punch and hammer to make an indent in the
adapter sleeve to prevent it from slipping.
25
26
7. Insert the outer fitting, with adapter sleeves if necessary, into the door
from the outside.
27
Ø mortise lock fastening hole
5.5 mm–6.3 mm
6.4 mm–7.3 mm
7.4 mm–8.7 mm
≥ 8.8 mm
8. Insert the escutcheon base into the door with the sleeve nuts on the
outer side.
28
9. Position the adapter plate on the door.
29
10. Align the adapter plate so that the spindle is precisely centred and the
adapter plate is perfectly perpendicular.
30
11. Screw the adapter plate firmly into place (PH2, torque 1.1 Nm).
31
12. Screw the escutcheon base into place on the inner side.
32
13. Insert the dummy cylinder.
32 / 60
Adapter sleeves
No adapter sleeves
6.4 mm
7.4 mm
8.8 mm
Digital SmartHandle AX Reader on both sides
NOTE
Feed the blank cylinder into the hole using a screwdriver
It is difficult to position the blank cylinder correctly, especially in thick doors.
1. Insert a screwdriver into the hole in the blank cylinder.
2. Position the blank cylinder using the screwdriver.
33
34
14. Screw the dummy cylinder firmly into place (PH2, torque 1.1 Nm).
35
15. Wait five hours for the anti-slip coating to set.
NOTE
Rest time for anti-slip surface
The supplied adapter plate feature a non-slip surface. This requires a settling
time for it to be fully effective.
1. After installing the adapter plate, wait five hours before continuing with
the installation.
2. If you need to finish installing beforehand, do not turn the handle as far
as it will go.
36
16. Remove the cover with the tool.
37
17. For 7 mm spindle: attach the adapter sleeve to the spindle.
22
18. Insert the fitting into the adapter plate.
39
19. Rotate the fitting until it is straight.
40
20. Screw the fitting firmly onto the adapter plate to prevent it from twist-
ing.
41
21. Place the cover on the fitting.
42
22. Place the outside handles on the fittings.
23. Place the covers on the escutcheon bases.
43
24. Fasten the grub screws firmly onto both handles (TX15, torque 5.0 Nm).
44
9 Fitting is now installed.
10. Removing the fitting
1.5 mm hexagonal wrench available.
ü
1. Remove the fitting in the reverse order to installation.
2. Insert a 1.5 mm hex key into the hole in the spindle mount in the fitting.
45
3. Bend the hex key to the side where the hole is located while pulling on
the outside handle.
46
9 Fitting is now removed.
EN