Publicité
BATTERY REPLACEMENT
The fire is supplied with an IR multifunction remote.
Before the remote will operate the plastic insulating
sheet needs to be removed.
Battery Requirements: Cr2025
1. Locate and remove the battery bracket.
2. The battery has two sides, one with a button feature, and the other is flat.
3. Insert the battery with the button side down into the battery bracket, making sure
the battery is firmly seated.
Batteries should be removed if the product is to be left unused for a long period of
time.
The batteries may contain hazardous substances that could endanger the
environment and human health.
This symbol appearing on the battery and/or packaging indicates that used
batteries must not be processed with municipal waste. Instead they should be
brought to the appropriate collection point for recycling.
By correctly disposing of used batteries, you prevent potential negative
consequences for the environment and human health. Recycling used
materials also preserves our natural resources.
For more information about collecting and recycling used batteries,
please contact your local municipality, your waste disposal service
or the store where you purchased this product.
SAFETY CUT-OUT SYSTEM
NOTE: The LED display panel will remain operational if the cut-out is activated,
only the fan heater elements are prevented from operating.
This product has one non-self-resetting overheat protection device (thermal cut-
out) which will activate if the air inlets or outlets are obstructed. For safety reasons
the fire will NOT switch on again automatically, the following procedure must be
carried out before the fire can be operated.
NOTE: The visual effect will remain operational if the cutout is activated, only the
fan heater is prevented from working.
Switch OFF the appliance at the wall socket or outlet. Leave the fire OFF for a
period of no less than 10 minutes, ensuring all obstructions are removed. Switch
the appliance ON at the wall. Ensure the appliance is turned ON at the control
switches. If the fire fails to operate correctly, repeat the above procedure. If an
attempt to switch on the appliance is made before the safety cutout has reset, the
appliance may cut out for a further period of time. If the sequence has been
followed correctly and the appliance still fails to function, check the fuse in the wall
outlet. If this is not the cause, call an electrician or maintenance engineer.
CLEANING AND MAINTENANCE
ALWAYS DISCONNECT THE APPLIANCE FROM THE MAINS SUPPLY OUTLET
SOCKET BEFORE UNDERTAKING ANY CLEANING OR MAINTENANCE!
For general cleaning use a soft clean duster - never use harsh abrasive or cleaners.
The glass viewing screen should be cleaned carefully with a soft cloth.
If in doubt consult a qualified electrician.
Excluding fuses, use only genuine manufacturers spare parts available from your
supplier.
Replacing the remote control battery:
When the battery becomes weak, the range of the remote control becomes shorter.
Replace the battery with a new Cr2025 lithium battery.
NOTE: Keep the lithium battery out of the reach of children.
23
EN
Publicité
