E.s.e. Pads; Factory Setting; Automatic Switching Off; Making Milk Froth - Graef Milegra Instructions D'utilisation

E.S.E. PADS

Note: Warm up the filter folder, the system and the cup. See preparation.
• Dry the group handle after preparation.
• Insert the filter insert for E.S.E. Pads.
• Place one or two cups underneath the outlet.
• Press the
• Remove the group handle after completing the process.
• Remove the pad into a used coffee tray (not included in the scope of delivery).

FACTORY SETTING

Press the button until a beep sounds.

AUTOMATIC SWITCHING OFF

To save energy, the device turns off after approximately 30 minutes when not in
use. In order to reactivate the device, press the

MAKING MILK FROTH

Notice: Ideal way to produce the cappuccino is to start from the coffeee (grinding
and then brewing) and then to froth the milk and pour it on top of it. In fact, to
keep the temperature of the coffee under control if the consumer will make a cap-
puccino in the opposite way (first frothing and then brewing) , there are 30 seconds
of waiting between steam frothing and coffee brewing. During this time the button
"coffee" is blinking.
If the unit is switched off, switch it back on again
• Pour cold milk into the milk jug.
• Hold the steam distributor above the drip tray.
• Turn the rotary knob to
• Wait a moment for steam to go away.
• Once the steam was escaped, turn the rotary knob back to the centre position .
• Swivel the steam distributor outward.
• Dip the steam distributor at a slight angle of approx. 1-2 cm (at an angle of
approx. 45 deg.) and not straight into the milk jug. The narrow spout can be
used as a guide.
• Turn the rotary knob to
• Add air until the milk volume has increased by about half (drawing phase).
Note: You will have achieved the right position if you can hear kind of a "sip
noise". This may be absent for a short time as the surface of the milk is in motion.
• Now hold the distributor a little deeper into the milk so that no more new air is
drawn. Milk should be put into rolling motions (rolling phase).
• Turn the rotary knob back to centre position as soon as the milk jug gets to hot
to be held.
• Pull the steam distributor out of the milk jug first.
38
or button.
. Steam light switch on blinking.
.
button.
.