Informations Pour L'utilisation Et L'entretien; Pour De Meilleurs Résultats; Interrupteur D'éclairage; Commutateur De Réglage De Vitesse Du Ventilateur - Bertazzoni KTV30XV Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INFORMATIONS POUR L'UTILISATION ET L'ENTRETIEN

Pour de meilleurs résultats
Activez la hotte quelques minutes avant de commencer à cuisiner pour créer un flux d'air
adéquat. Laissez la hotte fonctionner quelques minutes après avoir fini de cuisiner pour
absorber toute la fumée et les odeurs de la cuisine.
Panneau de commande de la hotte
Toutes les commandes sont situées sur le côté droit de la hotte.
Interrupteur d'éclairage
L'interrupteur de l'éclairage DEL se trouve derrière la garniture avant. Placer l'interrupteur à la
position 1 pour allumer l'éclairage. Placer l'interrupteur à la position 0 pour éteindre l'éclairage.
Commutateur de réglage de vitesse du ventilateur
B sur la FIGURE 10 représente le commutateur de réglage de vitesse du ventilateur. Placer
le commutateur à la position 1 pour allumer le ventilateur à la vitesse RÉDUITE. Placer le
1
15/32"
commutateur à la position 2 pour allumer le ventilateur à la vitesse MOYENNE. Placer le
commutateur à la position 3 pour allumer le ventilateur à la vitesse ÉLEVÉE. Placer l'inter-
rupteur à la position 0 pour éteindre le ventilateur.
3/4"

Fonctionnement automatique

Si le commutateur du ventilateur et l'interrupteur de l'éclairage sont allumés, le ventilateur et
l'éclairage sont activés automatiquement quand le panneau coulissant est ouvert, et ils sont
désactivés quand le panneau coulissant est fermé.
USE AND CARE INFORMATION
Rangehood Control Panel
All controls are located on the right side of the rangehood.
Light On/Off Switch
TheOn/Off switch for the halogen light is located behind the
front trim. Moving the switch to the 1 Position turns the light
On. Moving the switch to the 0 position turns the light off.
Blower Speed Switch
B in FIGURE 10 shows the speed control switch for the
blower. Moving the switch to the 1 Position turns the blower
on LOW. Moving the switch to the 2 Position turns the blower
on MEDIUM. Moving the switch to the 3 Position turns the
blower on HIGH. Moving the switch to the 0 Position turns
the blower off.
Automatic Operation
As long as the blower and light switches are on, the blower
and light will automatically operate when the visor is opened
and shut off when the visor is closed.
For Best Results
Start the rangehood several minutes before cooking to develop
FIGURE 10
B
23

Publicité

Table des Matières
loading

Table des Matières