Frigelux RETT136A Manuel D'instructions page 30

otherwise condensation will occur on the cabinet. Never place the appliance in a wall
recessed or into fitted cabinets or furniture when it is working, the metal grid at the back may
become hot and the sides warm.
Never place the Fridge in a wall recessed or into fitted cabinets or furniture when your Fridge
is working, the grille at the back may become hot and the sides warm. It must therefore be
installed so that the back of the Fridge has at least 10 cm of free space and the sides have
10 cm. Do not drape the Fridge with any covering.
Please follow below diagram for built-in installation:
Recommendation combination:
The following combination of drawers, baskets, and shelves is recommended for energy to
be used as efficiently as possible by the refrigeration unit.
Leveling the fridge
If the fridge is not level, the door and magnetic seal alignment will be affected and may
cause your Fridge to work incorrectly. Once the fridge is placed in its final location, adjust
the leveling feet at the front by turning them.
Cleaning before use
Wipe the inside of the fridge with a weak solution of bicarbonate of soda. Then rinse with
warm water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy
water and dry completely before replacing them in the fridge.
Before plugging in
Check that you have an outlet that is compatible with the plug provided with the refrigerator.
If this is not the case, see the section entitled ELECTRICAL INFORMATION.
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FRIDGE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30
minutes before switching back on to allow the coolant fluid to settle.
30