Appliance Handling Safety; Safety Codes And Standards; Electrical Safety - Bosch Hgf1050Muc Instructions D'installation

IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
The appliance should only be used if installed by a
qualified technician in accordance with these installation
instructions. The manufacturer is not responsible for any
damage resulting from incorrect installation.
To eliminate the risk of burns or fire by reaching over
heated surface units, cabinet storage space located above
the surface units should be avoided.
If cabinet storage is to be provided, the risk can be
▶
reduced by installing a hood that projects horizontally a
minimum of 5" (127 mm) beyond the bottom of the
cabinet.
▶ Verify that cabinets above the cooktop are a maximum
of 13" (330 mm) deep.
WARNING
Remove all tape and packaging before using the
appliance.
Dispose of packaging in an environmentally responsible
▶
manner.
▶ Never allow children to play with packaging material.
Store small parts safely as they can be a choke hazard.
▶
1.4 Appliance handling safety
WARNING
Unit is heavy and requires at least two people or
proper equipment to move.
▶ Do not lift appliance by door handle.
▶ Remove the door for easier handling and installation.
See instructions in this manual.
WARNING
Hidden surfaces may have sharp edges.
▶ Use caution when reaching behind or under appliance.
▶ Wear gloves to avoid cutting fingers on sharp edges
during installation.
1.5 Safety codes and standards
This appliance complies with the latest version of one or
more of the following standards:
¡ CAN/CSA C22.2 No. 61 - Household Cooking Ranges
¡ CSA C22.2 No. 64 - Household Cooking and Liquid-
Heating Appliances
¡ UL 1026 - Electric Household Cooking and Food
Serving Appliances
¡ UL 858 - Household Electric Ranges
¡ ANSI Z21.1 / CSA 1.1 Household Cooking Gas
Appliances
¡ ANSI Z21.1b-2012 Household Cooking Gas Appliances
¡ Installation must conform with local codes or, in the
absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54 or, in Canada, the
Natural Gas and Propane Installation Code, CSA
B149.1.
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
1.6 Electrical safety
¡ Installer - show the owner the location of the circuit
breaker or fuse. Mark it for easy reference.
¡ If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
¡ Local codes vary. The installer is responsible for
ensuring that the installation, connections, and
grounding comply with all applicable codes. The
manufacturer is not responsible for improper installation
or the failure to follow appropriate local codes and
regulations.
¡ Be sure your appliance is properly installed and
grounded by a qualified technician in accordance with
the National Electrical Code ANSI/NFPA 70 latest
edition and local electrical code requirements.
¡ Only a power supply cord kit rated for this appliance
and marked "For Use With Ranges" shall be used.
¡ Refer to the rating plate for more information.
→ "Rating plate location", Page 19
WARNING
Before installing, turn power OFF at the service panel.
▶ Lock service panel to prevent power from being turned
ON accidentally.
For appliances equipped with a cord and plug, do not cut
or remove the ground prong.
▶ It must be plugged into a matching grounding type
receptacle to avoid electrical shock.
If there is any doubt as to whether the wall receptacle is
▶
properly grounded, the customer should have it
checked by a qualified electrician.
en-us
5