Testing The Cooktop Burners; Flame Characteristics; Conversion To Lp Gas; Converting The Pressure Regulator - Bosch Hgf1050Muc Instructions D'installation

en-us Conversion to LP gas
To test the door lock set the Self Clean mode. Confirm
4.
that the door locks when the lock icon appears in the
display.
12.1 Testing the cooktop burners
Each burner must be tested for proper lighting and proper
flame characteristics on the lowest and highest power
level.
Test all cooktop burners for proper ignition.
1.
Push down the knob and turn it to the ignition symbol
‒
⁠ .
Verify that the igniter/spark module clicks. When one
‒
burner is turned to , all burners will spark. Sparking
will continue as long as the knob remains at ⁠ .
Once the air has been purged from the supply lines,
‒
verify that the burner lights within four (4) seconds.
When the burner lights, turn the knob back to the off
position.
If any of the burners do not ignite, do not continue
‒
testing. Call Customer Service.
Test all cooktop burners for flame characteristics on the
2.
lowest setting.
12.2 Flame characteristics
The color of the flame tells you if the gas supply is properly adjusted.
Note: Allow the appliance to operate for 4 to 5 minutes before evaluating the flame. Some yellow streaking is normal
during the initial startup.
Flame Image
Completely or mostly
yellow
Yellow tips on outer
cone
Soft blue
13 Conversion to LP gas

Conversion to LP gas

Your appliance is equipped for use with natural gas on
Conversion to LP gas
delivery. It can be converted to LP gas supply.
The components required for conversion to LP gas are
contained in the LP conversion kit included with this
appliance, or are available from Customer Service.
→ "Customer Service", Page 19
Only a qualified technician or installer is authorized to
convert the appliance to another gas type.
Before carrying out the conversion, turn off the electricity
and gas supply.
16
Push down the knob and turn it to the ignition symbol
‒
⁠ .
Turn the knob quickly to the lowest setting.
‒
Verify that the flame is a minimum height of
‒
approximately ¼" (6 mm).
Verify that the flame is steady. The flame should not
‒
go out, lift or blow off of the burner. It should carry
over, or surround the entire burner.
Verify that the flame is the right color.
‒
→ "Flame characteristics", Page 16
If the flame goes out, does not carry over properly or
‒
is too large, contact Customer Service.
Test all cooktop burners for flame characteristics on the
3.
highest setting.
Push down the knob and turn it to the ignition symbol
‒
. Keep it pushed down until the burner ignites.
Turn the knob to the highest setting.
‒
Verify that the flame is steady. The flame should not
‒
go out, lift or blow off of the burner. It should carry
over, or surround the entire burner.
Verify that the flame is the right color.
‒
→ "Flame characteristics", Page 16
If the flame burns yellow or does not carry over
‒
properly, contact Customer Service.
Measure
Verify that the regulator is set for the correct fuel. Retest
after adjustment.
Normal for LP gas
Normal for natural gas
13.1 Converting the pressure regulator
WARNING
Turn off the electricity and gas supply before carrying out
the conversion.
Remove the storage drawer from the appliance.
1.
→ Page 12
Unscrew the nut on gas pressure regulator using a ⅝"
2.
(16 mm) or adjustable wrench.
Remove the protection cap.
3.