Sleeve Mounting - Magontec Correx UP 2.3-919 Notice D'utilisation

Operating Instructions CORREX
6.3 CORREX UP 2.3-919 scope of supply with mounting kit for retrofitting
®
The CORREX
alternatively used for:

sleeve mounting

insulated-hole mounting.
Check by comparison with the table below that the parts and components
supplied are complete and that the small bag is intact.
Number
1
1
1
1
1
1
1
1
1
1
1
1
2
1
1
The item numbers of the mounting kit correspond to the numbering in the
annex 'Mounting kits for retrofitting - arrangement of parts'
Note: The mounting kit for sleeve mounting requires prefitting of the screw fit-
ting set in acc. with chapter 7.1.2.1. The mounting kit for insulated hole moun-
ting is used as described in chapter 7.2.2.
30
UP 2.3-919
®
UP 2.3-919 system with mounting kit for retrofitting can be
®
Item Description
Titanium anode with thread bolt and seal washer
Plug-in potentiostat with pilot lamp
Connecting cables with connectors
Mounting kit in small bag containing:
1 Seal
2a Screw fitting G 3/4"
2b Screw fitting G 1"
2c Screw fitting G 1 1/4"
3 Insulation sleeve, small
4 Insulation sleeve, large
5 Diode board
6 Tooth lock washer with tab connector
7,8 Nut M8, galvanized
9 Flat nut M8, galvanized
Operating Instructions