Raider Pro RDP-ID28 Mode D'emploi page 13

from the drill hole to remove chips or dust. If during drilling to drill block up in holes, you should exclude drill. Use a change
of direction of rotation to remove the drill from the hole. Drill must be kept in alignment with the hole. Ideally, the drill should
be placed perpendicular to the surface of the material being processed. If the condition for perpendicularity is not respected
at work can lead to trapped or breakage in drill hole and injury to the user. Continued drilling at low speed the engine from
overheating threatens. Must make periodic breaks during work or to allow the drill to work on no-load maximum speed for
about 3 minutes. Do not obscure the openings in the hull used for ventilation of the engine.
8.13. Outdoor use.
Connect the machine only in installations equipped with electric switch Fi (safety shut-off switch with Residual protection
RCD Residual Current Device. RCD must be no more than 30 mA).
Make periodic breaks at work.
Keep and refer to the accessories carefully.
Do not throw the tool, do not overload, do not soak in water and other liquids do not use it for mixing adhesives and
concrete coatings.
9. Service and support.
9.1. Impact drill does not require additional lubrication or special maintenance. There are no parts requiring maintenance
by the user. Never use water or any liquid chemical cleaning drill. It should only be wiped with a piece of dry tissue. Should
always be stored in a dry place and ventilation holes in the body of the drill to be free.
9.2. Replacing carbon brushes.
Worn-out (shorter than 5 mm), up or broken engine carbon brushes should be replaced. Always replace both brushes
simultaneously. Work on replacement of carbon brushes entrusted only to qualified person with original spare parts in service
9.3. The repair of your power is best carried out only by qualified specialists, which used only original spare parts. This
ensures their safety operation.
10. Environmental protection.
In view of environmental protection electrical appliances, additional accessories and packing must be subject to
appropriate processing for reuse of the compound materials.
According the European Guideline 2012/19/EC for Waste Electrical and Electronic Equipment and its implementation
into national right, power tools that are no longer usable must be collected separately and disposed of in an environmentally
correct manner.
All manuals and user guides at all-guides.com
13