Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL
WARNING
THIS LAWN TOOL IS FOR OUTDOOR USE ONLY. DO NOT EXPOSE TO RAIN OR USE IN
DAMP LOCATIONS.
GUIDELINES FOR USING EXTENSION CORDS
Make sure your extension cord is in good condition. When using an extension cord, be sure to use
one of heavy enough gauge to carry the current your product will draw. An undersized cord will
cause a drop in line voltage resulting in loss of power and overheating. The table below shows the
correct size to be used according to cord length and nameplate ampere rating. If in doubt, use the
next heavier gauge. The smaller the gauge number, the heavier the cord.
MINIMUM GAUGE FOR EXTENSION CORDS (AWG)
Amp Rating
More Than
Not More Than
0
6
10
12
Be sure your extension cord is properly wired and in good condition. Always replace a damaged
extension cord or have it repaired by a qualified person before using it. Keep your extension cords
away from sharp objects, excessive heat and damp or wet areas. Use a separate electrical circuit
for your tools. This circuit must not be less than 12-gauge cord and should be protected with a
15-amp time delayed fuse. Before connecting the motor to the power line, make sure the switch is
in the OFF position and the electric current is rated the same as the current stamped on the motor
nameplate. Running at a lower voltage will damage the motor.
WARNING
THIS TOOL MUST BE GROUNDED WHILE IN USE TO PROTECT THE OPERATOR FROM
ELECTRICAL SHOCK.
SAVE THESE INSTRUCTIONS
(WHEN USING 120 V ONLY)
25' (7.6 m)
6
18
10
18
12
16
16
14
Total Length of Cord in Feet (meters)
50' (15 m)
100' (30.4 m)
16
16
16
12
9
150' (45.7 m)
16
14
14
12
14
12
Not Recommended
Publicité
Table des Matières
