Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
GENERAL MAINTENANCE
• Keep the chipper clean and in good repair for maximum performance and machine longevity.
• Before each use, inspect the switch and cord for damage.
• Check for damaged, missing, or worn parts. Check for loose screws, moving parts that are jammed
or any other conditions that may affect the operation.
• If abnormal vibration or noise occurs, turn OFF the tool immediately and correct the problem before
further use.
• Do not use the chipper until it is properly repaired or replaced.
CLEANING
WARNING
TO AVOID INJURY, ELECTRIC SHOCK, OR DAMAGE TO THE CHIPPER, NEVER ALLOW A LIQUID
TO FLOW INSIDE THE TOOL.
• Wipe the outside of the chipper with a dry soft cloth.
• Remove the hopper from the housing body before washing the inside of the hopper.
• Do not hose down or wash the tool with water.
WARNING
TO AVOID DAMAGE OR ELECTRIC SHOCK, DO NOT USE STRONG SOLVENTS OR DETERGENTS
ON THE PLASTIC HOUSING OR PLASTIC COMPONENTS. CERTAIN HOUSEHOLD CLEANERS
MAY CAUSE DAMAGE AND MAY ALSO CAUSE A SHOCK HAZARD.
WARNING (PROPOSITION 65)
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals known to the state of California to cause cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other masonry products, and
• Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemical: work in a well ventilated area, and work with approved safety equipment,
such as those dust masks that are specially designed to filter out microscopic particles.
18
Publicité
Table des Matières
