PRO-POINT 8835910 Mode D'emploi page 17

V1.0
CUTTING SETTINGS
CUTTING NOZZLES AND CUTTING SETTINGS
NOZZLE PLATE THICKNESS
SIZE
IN. MM
1/32 3 to 6
3/64 5 to 12 13/64 to
1/16 10 to
75
5/64 70 to
100
3/32 90 to
150
1/8 190 to
300
LIGHTING THE BLOWPIPE
WARNING! Wear personal protective equipment before igniting
the blowpipe to avoid a burn injury or blindness (see Safety).
1. Purge the acetylene fuel hose and blowpipe by opening the fuel
regulator valve to eject contaminants. Leave open for 5 seconds for
every 25 feet of hose. Close the fuel valve on the blowpipe.
2. Next, purge the oxygen hose and blowpipe in the same way. Close
the oxygen valve on the blowpipe.
3. Open the torch fuel valve approximately 1/8 turn. You want the
minimum amount of gas
4. Hold the spark lighter nozzle so it does not obstruct the gas flow.
Activate the lighter to ignite the gas.
6. Open the oxygen valve on the torch handle and adjust until the
feather disappears leaving a small inner flame. This is a neutral
flame.
7. An additional step for the cutting torch is to press the lever (G) to
introduce additional oxygen. The inner flame should not change if
properly set. Adjust if necessary.
Visit www.princessauto.com for more information
Victor Style Heavy Duty Cutting and Welding Kit
ACETYLENE
PRESSURE
INCH BAR
1/8 to 0.14
15/64
0.14
15/32
25/64 to 0.14
2-61/64
2-3/4 to 0.14
3-15/16
3-17/32 to 0.21
5-29/32
7-31/64 to 0.28
11-13/16
OXYGEN PRESSURE
PSI BAR PSI
2 1.5 to 2.0 21.7 to 29 8.7
2 2.0 to 3.0 29 to
43.5
2 3.0 to 4.0 43.5 to
58
2 3.5 to 4.5 50.75 to
65.25
3 4.0 to 5.0 58 to
72.5
4 6.0 to 7.0 87 to
101.5
8835910
GAS
CONSUMPTION
ACT OXY
L/M L/M
20-25
10
40-50
13 80-
110
14.5 130-
160
20 170-
200
27 350-
400
17