Table des Matières
Publicité
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
32527xx1, 74524xx1
Hole size in mounting surface
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• Models 32505xx1, 32510xx1, 32513xx1,
74505xx1, 74510xx1, 74513xx1 only: This
faucet does not include a drain or a pull rod.
• Models 32506xx1, 74506xx1, 2527xx1,
74524xx1 only: The drain is suitable for most, but
not all, lavatory sinks sold in the United States and
Canada. This drain is intended for use in a sink with
an overflow. If your sink does not have an overflow,
or if this drain is too small for the hole in your sink,
please refer to the instructions included
with the sink. Some sinks include special drain
2
15 - 75 PSI (1-5 Bar)
145 PSI (10 Bar)
120°-140° F (48° -60° C)*
158°F (70° C)*
1.2 GPM (4.5 L/min)
0.5 GPM (1.9 L/min)
1⅜" (34 mm)
1⅝" (40 mm)
installation instructions and/or parts. Others require
the use of a specialty drain. Hansgrohe is not
respnsible for the cost of a specialty drain.
The hot and cold supply hoses included with
this faucet are for use with ⅜ stops. If your
stops are a different size, purchase adapters
at your local plumbing supply store or home
center. Adapters are not available from
Hansgrohe.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicité
Table des Matières
