Operation; Cleaning And Maintenance - Lux Tools A-Rm-1X20/33 Set A Notice Originale

– Make that the collection box is securely
engaged.

Operation

Check before starting!
DANGER! Risk of injury! The
product must only be put into oper-
ation if no defects are found.
Ensure that any defective parts are
replaced before the product is used
again.
Check the safe condition of the product:
– Check whether there are any visible
defects.
– Check whether all parts of the product are
firmly attached.
Turning on the tool
Note: The product cannot be
switched on without the circuit
breaker.
► P. 6, fig. 6
– Insert the circuit breaker (21) (pay atten-
tion to the fit)
► P. 7, fig. 11
– Press and hold down the switch lock (8).
– Pull the switch on lever (1) and hold.
– Release the switch lock.
• The unit will switch itself on with approxi-
mately 2 seconds delay.
Switching-off the device
– Release the switch on lever.
Mowing
WARNING! Risk of injury! Before
starting work, check the area and
remove all objects which may be
kicked up by the unit.
– Guide the unit at an even, slow pace
(walking speed) and with as straight a
path as possible.
Important notes
• Always work at right angles to the slope.
• Try not to cut grass when wet.
• Use overlapping paths to produce an
even cutting pattern.
• Cut longer grass with a greater cutting
height initially, then cut crosswise using
the desired cutting height.
► P. 7, fig. 10
• If the air flap (22) closes, the collection
container is full and must be emptied.
Cleaning and maintenance
DANGER! Risk of injury! Carry
out the maintenance work
described here in person.
Improper maintenance work can
damage the device and lead to
injuries.
DANGER! Risk of injury! Before
carrying out any maintenance or
cleaning work, the machine must
be disconnected from the power
and secured to prevent accidental
switch on.
Cleaning and maintenance overview
Before each use
What?
General function check.
Check all screw connec-
tions and tighten if neces-
sary.
Cleaning the device
Clean unit immediately after every use. Dried
grass remains are very hard, and are very dif-
ficult to remove.
– Remove grass remains with a brush, and
a plastic scraper if required (do not use
sharp implements).
– Remove deposits on the wheels.
– Wipe the tool with a damp cloth.
– Never clean the unit with water or high-
pressure jet.
Changing the blades
CAUTION! Risk of injury! Never
touch the blade on the cutting
edge. Wear gloves at all times
when working with the blade.
Removing
► P. 7, fig. 12
– Loosen the blade screw (23) using a 14
mm hexagon spanner.
– Remove the blade (24) carefully.
GB
How?
Visual check.
37