SCHOLTES FN 36 XA S Mode D'emploi page 29

Automatic cleaning using the PYROLYTIC
cycle
During the PYROLYTIC cycle, the internal temperature
of the oven reaches 500°C. When the pyrolytic cycle is
activated, food and grime residues are burnt away. Dirt is
literally incinerated.
Keep children away from the appliance during the automatic
cleaning cycle as surfaces may become very hot. Particles
may ignite inside the oven as a result of the combustion
process. There is no cause for concern: this process is both
normal and hazard-free.
Before initiating the PYROLYTIC cycle:
• remove large or coarse food residues from the inside of
the oven using a damp sponge. Do not use detergents;
• remove all accessories;
• do not place tea towels or pot holders over the oven
handle;
• turn the SELECTOR knob to the "0" position.
! If the oven is too hot, the pyrolytic cycle may not start.
Wait for the oven to cool down.
! The cycle may only be started once the oven door has
been closed.
To activate the PYROLITIC cleaning cycle, press and hold
the button for approximately 4 seconds. The SET TIME
KNOB may be used to select the desired cleaning level; there
are three default time settings which cannot be modified.
1. Economy (ECO): turn the knob towards " ". Duration 1 hour.
2. Normal (NOR): initial level. Duration 1 hour and 30 minutes.
3. Intensive (INT): turn the knob towards " ". Duration 2 hours.
4. Press the button to confirm.
An end time for the PYROLITIC cycle (as for a normal
cooking cycle) may be programmed (see Programming the
automatic cleaning end time).
Safety devices
• the icon on the display, when lit, indicates that
the oven door was automatically locked as soon as the
temperature reached a high value;
• the icon indicates that the cleaning cycle may
be cancelled at any time by pressing the
• if a malfunction occurs, the heating elements will be
switched off;
• once the oven door has been locked, you cannot change
the duration and cycle end time settings.
Programming the automatic cleaning end time
1. Press the
numerical digits on the DISPLAY begin to flash.
2. Turn the SET TIME KNOB towards " " and " " to adjust
the hour value.
3. Press the button again so that the other two numerical
digits on the DISPLAY begin to flash.
4. Turn the SET TIME KNOB towards " " and " " to adjust
the minute value.
5. Press the
6. When the set time has elapsed, the text END appears
on the display and a buzzer sounds.
• For example: it is 9:00 a.m. and the Economy PYROLYTIC
cycle has been selected: default set duration 1 hour.
12:30 is scheduled as the end time. The programme will
start automatically at 11:30 a.m.
Programming has been completed when the
icons light up. The DISPLAY shows the PYROLITIC cycle
end time and duration alternately.
Once the automatic cleaning cycle is over
You will have to wait until the temperature inside the oven
has cooled down sufficiently before you can open the oven
door. You will notice some white dust deposits on the bottom
and the sides of your oven; remove these deposits with a
damp sponge once the oven has cooled down completely.
Alternatively, you can make use of the already heated oven,
in which case it is not necessary to remove the deposits,
they are completely harmless and will not affect your food
in any way.
button;
button until the icon and the two
button again to confirm.
GB
and
29