Thorough Cleaning - Philips MG5750 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

To contour the hairline around the ears, comb

the hair ends over the ears.

2 Tilt the appliance in such a way that only one

edge of the cutter blades touches the hair ends

when you shape the contours around the ears.

3 To contour the nape of the neck or sideburns,

turn the appliance and make downward strokes

(Fig. 14).

4 Move the appliance slowly and smoothly

following the natural hairline.

Hair combs

Attach a hair comb to the extra-wide hair trimmer

to evenly trim the hairs on your head. The

appliance comes with 4 hair combs. The hair length

settings are indicated on the combs. The settings

correspond to the remaining hair length after

trimming.

Comb

Hair comb

Attach a comb to the extra-wide hair trimmer.

2 Move the trimmer slowly over the crown from

different directions to achieve an even result.

Make sure the surface of the comb always stays

in contact with the skin.

Always move the trimmer against the

direction of hair growth (Fig. 15). Press lightly.

Make overlapping passes over the head to

ensure that all hair that should be cut has

been cut.

Fading hair comb

Attach the fading hair combs to the extra-wide hair

trimmer to trim the hair around the ears with a

faded result. The appliance comes with 2 combs.

Use both combs to trim hair around both ears.

Choose a hair comb based on the preferred

trimming direction of back to front or front to back.

Always make sure that you hold the side of the

comb with the short teeth closest to your ear.

Comb

Fading hair

combs

Attach the comb to the extra-wide hair trimmer

to trim the hair around the ear. Then attach the

other comb to trim the hair around the other

ear.

2 Place the appliance on your hair at the back or

front of your ear, depending on the trimming

direction you prefer. Always make sure that the

side of the comb with the short teeth is closest

to your ear.

3 Move the trimmer slowly around the ear, while

holding it steady (Fig. 16). For best results, move

the trimmer against the direction of hair growth

(back to front).

Precision attachments for use on face

Precision trimmer

Use the precision trimmer to create fine lines and

contours around your facial style, close to the skin

(to a length of 1/32in./0.5mm).

Hold the precision trimming head perpendicular

to the skin and move the trimming head

upwards or downwards with gentle pressure

(Fig. 17).

Nose trimmer

Use the nose trimmer to trim your nose hair and

ear hair.

- Make sure nasal passages are clean. Make sure

outer ear channels are clean and free from wax.

- Do not insert the tip more than 3/16in./5mm.

- Always clean the attachment after each use.

Trimming nose hair

Gently move the tip in and out of nose while

turning it around to remove unwanted hairs

(Fig. 18).

Trimming ear hair

Slowly move the tip round the ear to remove

hairs that stick out beyond the rim of the ear.

2 Gently move the tip in and out of the outer ear

channel to remove unwanted hairs (Fig. 18).

Cleaning

Do not rinse the handle under the tap, only the

attachments can be rinsed under the tap.

Never use scouring pads, abrasive cleaning agents

or aggressive liquids such as gasoline or acetone

to clean the product.

Never dry the trimmer teeth with a towel or tissue,

as this may damage the trimmer teeth.

Cleaning after every use

Turn off the appliance and disconnect from the

power outlet.

2 Remove any comb or cutting element from the

appliance.

3 Remove any hairs that have accumulated in the

hair chamber with the cleaning brush supplied.

4 Clean the cutting element and comb under a

warm tap (Fig. 19).

The handle is not suitable for cleaning under

the tap.

5 Carefully shake off excess water and let all

parts air dry completely.