HOMCOM 820-341V80 Manuel D'instructions page 7

UNIT
CLEANNING AND MAINTENANCE
1. Turn the POWER OFF.
2. Unplug the unit and let it cool completely.
3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. A mild
detergent can be used if necessary.
4. After cleaning, dry the unit with a soft cloth.
5. Wait until the unit is completely dry before use.
6. If the heater will not be used for a long time, pls take out the battery in the remote
control according to the following steps.
WARNING:
● DO NOT let liquid enter the heater.
● DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to
clean the heater. This may cause damage or deterioration to the surface of the heater.
● DO NOT immerse the heater in water.
STORAGE
1. Perform the cleaning procedures described in "Cleaning and Maintenance".
2. Wipe all parts to dry.
3. Pack the heater in a plastic bag and store it in a cool, dry place.
1.Turn the heater ON.
2.Press the Timer button.
LED display changes from the "temperature" to the "hours" option for
the timer. Hour options for the timer are 0 to 12 hours (in 1 hour
increments).
3. Continue to press the timer button to change the number of hours
the heater will run before powering itself OFF.
LED Display will ash selected hour increments for a few seconds,
then revert back to the set desired temperature. The heater will power
OFF when the internal heater clock counts down the hour increments
set.
FUNCTION
7