HOMCOM 820-341V80 Manuel D'instructions page 6

INSTRUCTION FOR USE
1. Place the heater on a firm, level surface.
2. With the power in the OFF position, plug the unit directly into a 120V AC electrical
outlet.
STARTING UNIT AND SELECTING HEAT MODE
UNIT
1.Turn the heater ON by pressing the ON/OFF switch in back.
NOTE: Once power is OFF, heating element will stop working.
Fan will continue for 30 seconds until heater has cooled.
2. Press the Mode button to toggle between the two heating
Modes, to Choose Low/High heat setting, or turn off the heater.
Notice:
When the heat function is used for the first time, a slight smell may be present. This is
normal and should not occur again unless the heater is not used for an extended period
of time.
Notice:
It is normal for the heater to cycle ON or OFF as it maintains the preset temperature. To
prevent the unit from cycling, you need to change the thermostat setting.
SELECTING DESIRED TEMPERATURE
UNIT
15-16-17-···-32 ℃
SETTING POWER OFF TIMER FUNCTION
Notice:
The POWER OFF Timer function will allow for the heater to power OFF after a certain
set time, and can only be set while the heater is in the on mode.
1. Press the temperature button to adjust unit to the desired
room temperature.
2. Select temperature from 15°C to 32°C.
NOTE: Once you have chosen the desired temperature, the heater
will remain on until room temperature increases to the set
temperature on the LED display. The heater will cycle ON and OFF to
maintain set room temperature.
FUNCTION
FUNCTION
6