Intec PR5037 Mode D'emploi page 14

Commissioning
The heater has three different heating modes: minimum, medium and maximum. Star mode is
used to light the stove.
1
- Open the gas valve on the bottle one or two turns.
- Press the regulator safety button (purge button).
- Press the stove control button to the star position and keep the button pressed.
- Press the piezo ignition button (several times if necessary) until the stove ignites.
- Press and hold the control button for 10-15 seconds until the stove lights.
- Once the stove is turned on, you can turn the knob to the desired mode using the rotary knob
to choose the heating power.
- To turn off the stove, turn the rotary knob to minimum mode, then close the gas bottle tap.
The stove can only be turned off by completely closing the gas bottle.
Attention! When the stove has just been lit, it may take some time before the three ceramic
panels light up.
Replacement of the gas bottle
- Always make sure the gas valve on the gas bottle is completely closed. Always allow the stove
to cool completely before changing the gas bottle.
- Never replace the gas bottle or regulator while the stove is still burning!
- Follow the steps described under 'Installation' to correctly install a new
gas cylinder.
Maintenance
- Always make sure the gas tap on the gas bottle is completely closed and the heater has cooled
down. Do not clean the stove while it is on, this can cause serious injury!
- The stove must be inspected regularly (annually) by an installer or safety specialist.
- Clean the housing regularly, both inside and out. Do not use
aggressive cleaning products, these can damage the paint.
- Check the pilot light regularly during. When in use, it should be uniformly blue. When the pilot
flame is yellow, the heater should be checked for contamination by an installer or specialist.
- Check the gas pipe and replace it if worn or damaged.
- It is strictly forbidden to carry out heating work yourself. Only an installer or specialist can carry
out work on the stove. The repair must be carried out with original parts!
- Try to keep the device closed when not in use (e.g. in the original box). This minimizes pollution
and allows you to enjoy your device for longer.
4
5
2
1. Piezo
2. Star position (ignition)
3
3. Minimum power
4. Average power
5. Maximum power
14