Publicité
OPERATING INSTRUCTIONS
The cordless screwdriver can be used to perform
tightening/loosening operations. For this purpose, bits
are used.
When operating the cordless screwdriver, you must
consider some use procedures:
▪ When working on small or loose parts, use clamping
devices to fix workpieces securely and stably;
▪ Do not apply excessive pressure on the machine
against the workpiece/object. If the speed drops
abruptly, reduce the pressure applied to the cordless
screwdriver immediately;
▪ When the bit gets jammed, switch off the power tool
immediately. Avoid the high reaction torques that
cause kickback;
▪ Never put the power tool down before the rotating
accessory has completely stopped;
▪ Switch off the cordless screwdriver immediately if
any of the following problems occur:
- Damage to the cordless screwdriver housing;
- Damage on the "ON/OFF" switch;
- If you sense smoke or burning smell.
Start and stop
1. Press the "ON/OFF" switch and place the bit on the
bolt to be screwed or unscrewed respectively;
2. To increase and decrease the rotation speed, press or
release the "ON/OFF" switch respectively. The
maximum speed is reached with the switch pressed
down completely;
3. To turn off the cordless screwdriver, release the
"ON/OFF" switch.
While the screwdriver is running, the LED light is on.
28
Selecting the direction of rotation and "ON/OFF" switch
lock
Do not change the direction of rotation while the
cordless screwdriver is running, it can cause serious
damage to the appliance. Always check the direction of
rotation before starting to use the machine.
1. Use the forward/reverse button, to select the shaft
direction of rotation:
▪ With the forward/reverse button set to the left,
the shaft rotates clockwise;
▪ With the forward/reverse button set to the right,
the shaft rotates counterclockwise;
▪ If the forward/reverse button is set in the middle
position, the ON/OFF switch is locked.
Publicité
