Publicité
▪ Make sure that the ventilation slots are not clogged.
Do not place any objects over the slots;
▪ The bits and the cordless screwdriver itself may
become too hot during operation. Avoid touching
them, they can cause severe burns;
▪ Make sure that you do not damage the electrical
circuits, gas and water pipes when operating the
equipment. Any damage to these installations can
cause fire, explosion, electric shock or property
damage;
▪ Make sure that you do not damage the electrical
circuits, gas and water pipes when operating the
equipment. Any damage to these installations can
cause fire, explosion, electric shock or property
damage;
▪ Materials containing asbestos cannot be drilled.
Asbestos is carcinogenic.
Maintenance and cleaning
Before carrying out cleaning, adjustment, accessory
replacement, repair or maintenance work, the
forward/reverse button should be set to the middle
position.
Replace worn out or damaged parts immediately, so
that the power tool is always in a safe operating
condition.
Cleaning:
The power tool must be thoroughly cleaned in its
entirety after use.
Do not use aggressive cleaning agents. These products
may damage plastics and metals, impairing the safe
operation of your power tool.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out, all other works must be
performed by an official dealer.
Keep all bolts well tightened to ensure a safe operation.
If any components or safety devices are removed for
maintenance works, they must be repositioned
immediately and correctly.
Use only ITOOLS-approved tools for this machine or
technically identical parts. Failure to do so may result in
personal injuries or damages to the cordless
screwdriver. If in doubt, if you lack knowledge or
resources, you should contact an official dealer.
Technical assistance
The cordless screwdriver should only be serviced by the
brand's technical assistance center, or other qualified
personnel, replacing any necessary parts with original
ones.
ASSEMBLY INSTRUCTIONS
Charging the machine
1. Plug the charger into the charging port (1);
2. Then plug the charger into the socket and let it
charge.
Only use the charger supplied.
Sometimes at the end of charging, both the machine
and the charger may be hot, but this does not mean that
they are malfunctioning.
Changing and inserting bits
The cordless screwdriver can be used to perform
tightening/loosening operations. For this purpose, bits
are used.
To use the screwdriving bits, both the chuck and the bit
holder are magnetic, so you only have to push the bit.
27
Publicité
