Publicité
▪ Check that all bolts are properly tightened. Regular
inspection is important to ensure safety issues and
the performance of the power tool;
▪ After fitting the accessories and before using the
device on a workpiece, run it at maximum no-load
speed for some time. Check for moving parts
misalignment or any other condition that may affect
the cordless screwdriver operation. Check that all
moving parts run smoothly, without abnormal
noises;
▪ Check that the safety devices are in perfect condition
and function properly. Never use the power tool if
the safety devices are missing, inhibited, damaged or
worn out;
▪ If the ON/OFF switch is damaged or does not allow
the operation of the cordless screwdriver to be
controlled, it must be repaired or replaced in order to
prevent any accidental start.
Make all adjustments and work necessary for the
correct assembly of the cordless screwdriver. If you
have any questions or difficulties, contact your official
dealer.
While operating
Keep third parties away from the power tool's
area of operation. Never work while animals or
people, especially children, are in the danger zone.
Keep the work area clean, organized and well lit (250 to
300 lux), thus decreasing the risk of accidents.
Always wear personal protective equipment and
clothing. Wearing a visor or goggles, dust mask, hearing
protection, anti-slip safety shoes, long-sleeved clothing,
gloves and helmet properly reduces the risk of injury.
Clothing worn during the appliance operation must be
adequate, tight and closed, for example, a work boiler
suit. Do not wear loose clothing or jewelry. Keep hair,
clothing and gloves away from moving parts.
The control and safety devices installed on the power
tool may not be removed or inhibited.
26
To avoid accidents, you should also take into
consideration
the
procedures:
▪ The accessories speed of the cordless screwdriver
must be at least equal to the maximum speed stated
in the technical data table;
▪ When operating the cordless screwdriver, adopt a
stable position and always keep your balance. Hold
the appliance firmly to ensure continuous operation
and withstand unexpected situations, such as
kickback;
▪ The kickback is a sudden reaction that happens when
the power tool is switched on and the bit gets
jammed. The accessory kickback forces the power
tool to rotate in the opposite direction to the rotation
of the accessory;
▪ The kickback occurs due to an incorrect use of the
power tool or due to an improper working procedure
which can cause serious injuries to the user. Loss of
control can result in serious injury. To avoid the
kickback, the following precautions must be
considered:
- Fit the accessory in the correct position and keep it
securely locked in place;
- Do not position your body in the area where power
tool will move if kickback occurs.
▪ Never put your hands near the bit. Keep your hands
away from the rotating parts;
▪ When the rotating accessory gets jammed, switch off
the power tool immediately;
▪ To avoid moving or projecting the workpiece/object,
use clamping devices or a bench vice to ensure that
work is carried out safely. Place and hold the
workpiece/object in the correct position and secure
it;
▪ Never put the power tool down before the bits has
completely stopped. The rotating accessory may
come into contact with the resting surface, causing
you to lose control of the cordless screwdriver;
following
precautions
and
Publicité
