Publicité
Les langues disponibles
Les langues disponibles
Installation & Charging
EN
Fully charge the appliance before first use.
1
1. Insert the end of the
2. Place the charging
handle vertically into the
base against a wall on
port on the top of the
level ground and connect
appliance until it clicks.
it to a power source.
* To disassemble, extend a hard object into the hole of
the appliance as indicated to press in the contacts and
pull the handle upwards at the same time.
Note:
• If there is no operation within 10 minutes of being fully charged, the appliance will
enter sleep mode. Please restart the appliance if you need to use it.
• To extend the battery life time, the battery keeps cooling down automatically after you have
used the appliance for a long time.
5
5
2
3
3. Place the appliance on
the charging base. When
the screen reaches 100%,
charging is complete.
Starting Cleaning
1
1. Press the clean water
2. Open the tank cover
tank release button to
and fill the tank with clean
remove the tank.
water.
4
4. Gently step on the floor brush
5.Briefly press the mode switch
and and recline the appliance
to switch modes according
backwards. Briefly press the
to your needs.
power switch button to
start/stop operating.
Note:
• Do not vacuum any foamy liquids.
• The appliance will be suspended in the upright position while running.
• Do not recline the appliance backwards more than 140° to prevent the appliance from
leaking water.
• The appliance is suitable for cleaning floors, marble, tiles and other hard surfaces.
• When the appliance is in operation, do not lift it off the ground, move it or tilt it. Otherwise,
the used water may flow into the motor.
EN
Click
2
3
3. Renstall the clean water
tank until it clicks.
5
6
6
Publicité
