Dreame G10 PRO Mode D'emploi page 4

Safety Information
EN
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Warning:
Any changes or modifications to this unit not
expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
MPE caution
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or
more should be maintained between the antenna of this device and persons during
device operation. To ensure compliance, operations at closer than this distance is not
recommended.
Product Overview
Packing List
Handle Charging Main
Base Body
3 3
Spare Replacement Power Replacement
Brush Filter Adapter
Roller
Product Overview
Floor Washer
1
2
3
4
5
6
7
8
9
1 Self-Cleaning Button
2
Mode Switch
3
Power Switch
4
Display Screen
5 Used Water Tank Release
Button
6 Used Water Tank Handle
7 Used Water Tank
Charging Base
1
2
Filter
15
14
13
12
11
10
8 Roller Brush Cover 14 Clean Water Tank Handle
Roller Brush
9 15 Clean Water Tank
Release Button
10 Roller Brush Handle
11
Roller Brush Release
Button
12 Roller Brush Cover
Release Buttons
13 Clean Water Tank
1
. Charging Port
2
. Charging Contacts
EN
4 4