FUXTEC FX-RMR66 Mode D'emploi page 46

Manual_FX-RMR66_Int24_rev01
Assembly the steering wheel
First Insert the sleeve into the steering wheel shaft, as shown in Figure 1, then Insert the decorative
cover as shown in Figure 2, insert the steering wheel and fix by bolt(M8x160) and washer, install the
decorative cover as shown in Figure 3.
Assembly the seat
This step has been pre-installed by manufacturer, the user can adjust the seat to forward or back.
(Align the holes on the seat with the holes on the fixing plate, secure the seat with bolt(M8x20)
washers, as shown in below Figure.)
46