Installation Steps - Avs 2814818 Instructions D'installation

Installation Steps

Clean painted surface of hood where scoop will attach with
alcohol pad.
3
Use scissors to trim excess gasket to be flush with
5
Apply decal to chrome accent piece.
7
Position chrome accent piece to top of hood scoop and apply
pressure to exposed tape.
9
NOTE: Actual application may vary slightly from illustrations.
scoop edge.
Free end of
tape liner
gasket
4
Clean top area of hood scoop with an alcohol pad.
6
Peel back 2" (5 cm) of tape liner from center flange of
bottom of chrome accent piece. Completely remove
tape liner from the remaining three (3) locations
Peel back 2" (5 cm)
of tape liner
8
With the chrome accent piece in its final position, remove remain-
ing tape liner by pulling on free ends. Apply pressure to all edges
10
Repeat Steps 7-10 for remaining chrome accent piece.
Page 2 of 3
Affix gasket to hood scoop edge.
tape liner
Completely remove
to ensure adhesion.
tape liner