Operating The Fan; Oscillation Function; Height Adjustment - Homcom 824-021 Mode D'emploi

6. Position Rear Guard (4) (Handle upper most)
over the motor shaft and secure tightly to the Fan
Motor (9) with the Four Screws (3) provided. See
picture.
7. Align the Fan Blade (2) with the flat part on the Motor Shaft (6) and secure with the Fan Blade
Screw (5) until tight.
8. Open the Clips on the Front Guard (1) and place the Front Guard (1) onto the Rear Guard (4), (align
locking screw holes at the bottom of the Guards and close the Clips over the outer rim.
9. Secure both Guards with the Screw and Nut through the rims at the bottom. Fig1.
Fig 1

OPERATING THE FAN

This Metal Stand Fan is for domestic use, it is not intended for industrial or commercial use, your
Pedestal Fan is safe and easy to use.
Place the fan on a flat, level surface and ensure it is stable.
Put the plug in the wall socket making sure the power cable does not pose a trip hazard.
• SPEED FUNCTION (8)
This fan has 3 speeds for your comfort and convenience.
I - Low speed.
II - Medium speed.
III - High speed.
0 - Off button to stop the fan working.

• OSCILLATION FUNCTION (7)

The Metal Stand Fan has an oscillating function (side to
side swing) to cover large areas for your comfort and
convenience.
To activate this function, loosen the knob (7) and the head
will automatically oscillate from left to right and back again
when the fan is switched on.
Lift the oscillation knob (7) to stop this function and the air
will only flow in one direction.

• HEIGHT ADJUSTMENT

The height of the fan can be adjusted by turning the Height Adjustment
Screw (12) anti-clockwise to loosen the Inner Tube (11).
Adjust the Inner Tuber (11) to the desired height and firmly tighten the
Height Adjustment Screw (12).
Fig. 2